1
Briggs Flathead / carb question
« on: August 10, 2006, 10:47:59 pm »
what are the numbers on the engine tag?
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Kohler Engines / kohler 15.5 hp motor wont start!!!!!!!
« on: August 10, 2006, 02:58:11 pm »
Sounds like an anti fire switch.
I removed the nut where the wire goes into the carb and removed the needle and spring.
I removed the nut where the wire goes into the carb and removed the needle and spring.
3
Chassis / big fourwheeler tires on mower
« on: August 08, 2006, 12:52:49 pm »
Same size and bolt pattern as stock but off a cub cadet.
I have regular turf tires on my stock rims.
I still mow the grass with this tractor.
I have regular turf tires on my stock rims.
I still mow the grass with this tractor.
4
Driveline / Deal on new 700-039 update
« on: August 07, 2006, 07:42:24 pm »
Only as I come across them.
Im really patient when part searching and there are many lawn machine junk yards around here.
Im really patient when part searching and there are many lawn machine junk yards around here.
5
Briggs Flathead / hard to start engines
« on: August 07, 2006, 07:39:29 pm »
model - 289707
type - 0154 01
code - 9303244E
12.5hp I/C Briggs
Got it for free and has a rough looking carb but i think it can be cleaned up after replacing a small broken piece.
It started after turning over just a few times on starter fluid with no gas feed and ran for about 5 seconds.
My question is why does it turn over hard? especially in one certin spot.
Is this a valve problem?
How do I fix it?
Tony
type - 0154 01
code - 9303244E
12.5hp I/C Briggs
Got it for free and has a rough looking carb but i think it can be cleaned up after replacing a small broken piece.
It started after turning over just a few times on starter fluid with no gas feed and ran for about 5 seconds.
My question is why does it turn over hard? especially in one certin spot.
Is this a valve problem?
How do I fix it?
Tony
6
Driveline / Deal on new 700-039 update
« on: August 07, 2006, 04:26:13 pm »
I got a used one today (700-039) and a john deere 111 with a blown motor for $10 :shock:
7
Driveline / A ballpark setup to start?
« on: August 07, 2006, 12:36:30 am »
What kind of rpms does this basic setup put into the tranny?
8
Tires / big tires wheels
« on: August 05, 2006, 11:15:53 pm »
Just atv tires on your rims will make it way more capable.
I think wider tires with lower pressure hook up best.
I like snow hogs on the front.
what side rimes do you have front and rear?
I think wider tires with lower pressure hook up best.
I like snow hogs on the front.
what side rimes do you have front and rear?
10
Post your Pics! / check out my mowers
« on: August 05, 2006, 09:18:13 am »
Curious to how you measure the speed accurately.
That is haulin some grass right there.
My car is singing at 90 mph.
I would fear for my life on any of the mowers pictured above. :shock:
That is haulin some grass right there.
My car is singing at 90 mph.
I would fear for my life on any of the mowers pictured above. :shock:
12
Driveline / 700 Series transmission?
« on: July 28, 2006, 04:30:27 pm »
I noticed there are many differnt variations in the peerless 700 tranny.
Some are cheaper than others.
Which one of these are the best?
Why the difference in cost?
Will any of these work?
Where can I purchase the sprocket for the drive?
Thanks,
Tony
Some are cheaper than others.
Which one of these are the best?
Why the difference in cost?
Will any of these work?
Where can I purchase the sprocket for the drive?
Thanks,
Tony
Pages: [1]