Hey Guys,

Been reading and enjoying for a brief while now. Thought I would put this out there to hopefully get some constructive feedback and advice. I'm sure many of you builders have a stand with all your needed electrical that stays with it, I needed something mobile that I can take to the engine. This is my first version, I could really use a couple more. Most of the components were things I had around from salvaging other pieces of equipment. Not a 100% done but you can get the idea. I just stuck to the basics and tried to keep this first one kinda simple, yet hopefully pretty universal. I'm thinking I'd like to add a little diagnostic and tuning components to the next version, but unsure which since space is a premium and so is keeping the cost down.

Your feedback or helpful tips and hints are greatly appreciated.


Need to finish triming for the throttle lever and make bracket along with finishing the lead set.


Ya know that yellow wire was just uncooperative from the beginning.


Lead set and throttle. Need to find a source or part numbers for those B&S connectors to make connecting easier.


I got a little lax on the wire control since I hastfully grabbed some stiffer stranded wire I had laying around to get started. It made tight bends and good wire control a pain, should have been more patient and got the right stuff.


Thanks for reading, reko