Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Carney301

Pages: [1]
1
Briggs Flathead / 11 horse 25 cube questions
« on: November 12, 2009, 08:35:50 pm »
is the 25 cubic inch briggs a good choice to start out with? does it have any known weaknesses? can i just disconnect the governor from outside the block and run it like that? What have all you guys done? I need some info thanks

2
The Ladies' Room! / any girls mower racin near western maryland?
« on: November 12, 2009, 07:03:13 pm »
i am very suprised to find that this many girls actually give a crap about racin mowers. I am currently attempting to build a general lee racing lawn mower from a 80's craftsman.

3
Driveline / tranny questions
« on: November 12, 2009, 06:57:12 pm »
say i put car wheels and tire on the mower and change the pulleys to make it go faster will this mess up the transaxle (peerless)?

4
Briggs Flathead / More opposed twin questions
« on: July 22, 2009, 10:03:12 am »
I was reading that the g team has racing cams but do they have any for my 42 ci opposed? Or does anyone?

5
Briggs Flathead / Briggs 18 horse opposed twin
« on: July 15, 2009, 04:54:03 pm »
Are the heads on this engine strong enough to race with them? If not where do you get racing heads with higher compression?

6
Briggs Flathead / what you do to the tractor
« on: July 06, 2009, 03:46:00 pm »
What was the first thing you guys did when you got your junk mowers? I have mine running and i know i have to change pulleys but what else can i do?

7
Related Events / Near Western Maryland
« on: July 04, 2009, 11:31:00 am »
Can anyone tell me if there is anything goin on near Cumberland MD

8
Driveline / tranny issues
« on: July 04, 2009, 11:18:42 am »
i pulled the transaxle out of my future "racing mower" and i tryed to pull the bip pulley off to put a smaller one on for more speed. But i couldnt get it off even with a Big Hammer and a propane torch. I need some help

9
Driveline / What ratio should i use
« on: July 04, 2009, 11:09:11 am »
What ratio should i use for the drive belt to reach racing mower wheel speed? And what is the best way of not kiling the transaxle...

10
Briggs Flathead / Making engines more powerful
« on: July 04, 2009, 10:59:10 am »
I was wondering what the best way is to get the most power out of a lawnmower engine and how should i set up the throttle?

Pages: [1]