Heymow - Lawnmower Racing Forum
Mower Building / Setup Help => Chassis => Topic started by: BPLP on November 16, 2017, 08:46:38 am
-
Would it be possible, or more so a good idea, to make the frame that the body of my mower will fit over and then drill holes and bolt the two together? I was going to weld them but together but then it might be hard to keep it from distorting from the heat and so on. Also I think it might be better for maintenance. (this is not going to be a racer so those restrictions don't really apply to me.)
-
Sure, most guy want to do that but we have to use mower frames.
-
Yeah that's what I thought. I think it would be best just so I can pull the whole body off the frame like an old car or truck. Should I put the bolts through the side of the frame or the top though? would it make a difference?
-
Just put pins on the stuff you raise up, and bolts for fenders