Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - lil_broge

Pages: [1]
1
Briggs OHV & Vanguard / Re: 35 inch vanguard
« on: December 26, 2014, 12:35:48 am »
That needle will work for the single carb too. You just have to remove the plug or the after fire solenoid.

2
Briggs OHV & Vanguard / Governed single not running right
« on: May 16, 2014, 03:34:57 pm »
ok so im working on a 28 ci governed single that runs great with the choke closed. so my thought was it needed more fuel. if i turn either screw all the way out it does not change. then i swaped the carbs with no change and then the intakes no change. checked for leaking gaskets and nothing. so im turning to you guys. i did not find this anywhere. if it has been covered please attach the link. cause im out of ideas any input would be helpful.

3
George summed it up. The main issue is stopping the drain back.

4
I tried this very same idea. I made a pick up for the stock oil pump and tested it on the bench with a custom tool to turn the oil pump with a drill to see if the stock pump could pull the oil out of the bottom of the block. The issues i ran into was the oil drained out of the system when the motor was turned off. Also I realized no oil was getting to the rockers or valves. As for the carb issue i had an E.C. carb adapter and used that to rotate the carb 90 degrees. I also made a custom engine stand to hold the motor using the stock mounting pattern. I ran the motor for about a min and nothing blew up but I shut it off because no oil was getting to the valves.

Pages: [1]