Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Burton for Certain

Pages: 1 [2] 3 4 ... 57
16
Post your Pics! / Re: New Mower build
« on: June 11, 2013, 03:02:28 am »
That's a Rugg. AP or FX.

17
Kohler Engines / Re: Cams
« on: June 07, 2013, 11:56:19 am »
All the parts except block and oil pan/closure plate will interchange. Head gaskets differ a bit for oil drainback, but can be modified.

18
Coffee Shop / Re: battery tie downs
« on: June 07, 2013, 06:58:56 am »
Zip ties.

19
Kohler Engines / Re: Ok all I know is thier heavy
« on: June 03, 2013, 10:43:02 am »
Balancer runs the oil pump.

20
Coffee Shop / Re: opinions needed please.....
« on: June 02, 2013, 01:34:41 pm »
Deal directly with the manufacturer any time you can.

21
Briggs OHV & Vanguard / Re: 40 intek 21 hp???
« on: June 02, 2013, 09:34:26 am »
If you're going to spend all that $ on the twin...why not spend it on your Cp motor?

22
Driveline / Re: a question on front and rear axle placement
« on: May 25, 2013, 10:26:27 am »
You can raise and lower the axle in the frame at the stock location. So its best to tack weld 4" tabs off the bottom of your frame and then get your wheels and tires. Then cut the frame so everything fitsnice and neat.

23
Chassis / Re: what chassis
« on: May 20, 2013, 10:21:10 pm »
I think that's what he meant Tank.

24
Kohler Engines / Re: Kohler V-Twin discussion
« on: May 18, 2013, 09:09:18 am »
They're the same heads.

25
Kohler Engines / Re: Kohler cv15 carb
« on: May 15, 2013, 05:29:56 pm »
Valve cover on the top side. Brass is fine.

26
Coffee Shop / Re: Urethane Skateboard Roller for Chain Tensioner
« on: May 15, 2013, 03:01:17 pm »
I ran them on my bp and Cp last year. No issues. I used good bearings though

27
Newcomers / Re: command single
« on: May 14, 2013, 08:50:53 am »
A few guys in Wisconsin have done it. Call matt kaster at Fathead Engineering.

28
Post your Pics! / Re: 2013 Midwest Super Cub FXS (CUBZILLA)
« on: May 11, 2013, 06:01:47 pm »
Due to space issues, had to change the hood a final time.


Bad thing about this motor is the carb is coming straight back at me.




Going to pickup the engine and clutch at the end of the month. The US race in Iowa will be the maiden voyage.

29
Tires / Re: where do i get 16x7.5-8s?
« on: May 08, 2013, 08:21:25 pm »
No tubes. I usually eBay all my tires. I've seen them as much as half the price of a local lawn mower shop.

30
Driveline / fxs gear ratio
« on: May 06, 2013, 01:51:52 pm »
What kind of gear ratio yall run on a fxs with 15-8-8 hoosiers?

Pages: 1 [2] 3 4 ... 57
anything