1
Coffee Shop / has anyone talked to hitch
« on: June 11, 2011, 12:46:37 am »
cant seem to call at the right time.does anyone know what his e-mail is?
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Briggs OHV & Vanguard / connecting rod length
« on: January 13, 2011, 12:47:57 am »
are the rods the same in the 44ci and the 49ci?
3
Tecumseh Engines / thinking about a v-twin build
« on: January 12, 2011, 10:51:23 pm »
what is the biggest piston that can be used in a tech with a resleeve?is the head design better than briggs?what makes this engine or build better than briggs?i see briggs has a 28-30hp out now
4
Briggs OHV & Vanguard / 21ci ohv briggs question
« on: December 01, 2010, 09:19:06 pm »
has anyone built one?can you tell me if the arc rod for the flatty work?
5
Briggs OHV & Vanguard / 33ci ohv bore size?
« on: July 15, 2010, 02:42:48 am »
can anyone tell me what size the bore is? and if they have ever stuffed one in a flatty?
6
Briggs OHV & Vanguard / timeing 31 non avs single with offset coil help
« on: March 27, 2010, 01:55:07 pm »
im useing the arc wheel off my flatty and read several posts.without running out to buy a degree wheel do i need to get the avs hub,use offset key,slot the hub or run it all the way retarded.can anyone tell me were it would sit around 28*to be safe.
7
Briggs OHV & Vanguard / arc rod clearance 31ohv single non avs
« on: February 07, 2010, 02:33:59 pm »
this is a large journal crank with 6279rod,are you guys taking material off the case/rod or both to get clearance?
8
Briggs OHV & Vanguard / ohv singles breather/oiling?
« on: January 27, 2010, 06:44:36 pm »
do you need to do any breather or oil passage mods like don g does on the flattys?second breather hole in the case for catch can and drill passage hole from inner crankcase into breather compartment?if im missing anything please let me know.
9
Briggs Flathead / j&e piston for model 19
« on: January 18, 2010, 03:10:44 am »
what is the biggest j&e piston size with a sleeve i could get in there without blowing head gaskets and scattering engine parts.will also be running arc rod,bigger valves ect. any input from past experments would be appreciatedand does any one know were i could bye the seat puller&cutters?
Pages: [1]