Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - KEN ROBINSON

Pages: [1] 2 3 ... 8
1
Racing Mower Builds / Re: New SUPER MODIFIED Single build.
« on: May 21, 2016, 07:23:40 am »
thanks

2
Racing Mower Builds / Re: New SUPER MODIFIED Single build.
« on: May 19, 2016, 02:29:27 pm »
i have a question for george.how wide are the frame rails outside to outside

3
Garden Tractor Pulling / bolens
« on: May 15, 2016, 05:48:49 pm »
is a fmc bolens h16 a good for pulling?

4
Briggs OHV & Vanguard / model 31
« on: March 31, 2016, 06:46:52 pm »
are all briggs singles with ohv model 31's?

5
Driveline / Re: clutch
« on: March 28, 2016, 03:38:01 pm »
well ya its a racer,why else would i be asking
this is what i'm building

6
Driveline / Re: clutch
« on: March 27, 2016, 09:38:39 am »
ok.thanks.i getting a clutch with a 3" pulley on it and using a 700 trans. with a v twin,what size pulley should i use on the transmission

7
Driveline / Re: clutch
« on: March 25, 2016, 06:10:28 pm »
just asking bacause i have seen some with both in the build threads

8
Driveline / clutch
« on: March 25, 2016, 09:15:12 am »
do you use a mechanical clutch if you have a centrifugal clutch?

9
Driveline / clutch and jackshafts or comet torqe converter setup
« on: March 19, 2016, 07:10:17 pm »
i'm using a predator 420cc engine,short track.what setup would be easyer to tune

10
Coffee Shop / Re: BUILDING STAND
« on: November 03, 2014, 08:39:34 am »
I use an old hospital bed.  Works awesome.  Plug it in and adjust height by pushing a button.
[/URL]

COOL! good idea

11
Coffee Shop / Re: BUILDING STAND
« on: November 02, 2014, 08:04:35 pm »
lets see some pictures!!

12
Coffee Shop / BUILDING STAND
« on: November 02, 2014, 03:25:04 pm »
show what you use when building a racing mower so newbee's can get some ideas

13
Chassis / Re: SPINDLES
« on: October 15, 2014, 07:17:51 pm »
cold rolled steel.i will just use bolts then

14
Chassis / SPINDLES
« on: October 15, 2014, 06:54:42 pm »
i want to make my own spindles.are the spindles you buy just 5/8 bolts? i got kart 3 hole hubs and they seem a little sloppy on a 5/8 bolt.i have some 5/8 steel rod and it wont fit in the hole.i could turn the rod down on my lathe.would that be better than using bolts?

15
Racing Mower Builds / Re: Sami's S/S
« on: October 15, 2014, 06:42:40 pm »
Sami put the chassis together and bolted on the fenders, tires and wheels...



I did the set up on the axel, chain and brakes...

Little tight in there, but all fits and rolls smooth..



what did you use for the chain tensioner?

Pages: [1] 2 3 ... 8
anything