1
Driveline / Need Help with MTD pulley swap
« on: June 11, 2014, 01:42:29 pm »
I am going to preform a pulley swap on my MTD and what i have read it to mesaure your drive pulley and then measure your pully that is attached to the motor and flip them so like
front 10 inch
back 5 inch
you want to keep the same ratio so you dont have to change the belt so
front 4
back 11
is there anything i need to know to preform this ? any help? any tips?
front 10 inch
back 5 inch
you want to keep the same ratio so you dont have to change the belt so
front 4
back 11
is there anything i need to know to preform this ? any help? any tips?