Heymow - Lawnmower Racing Forum
Engine Help => Briggs Flathead => Topic started by: strokerwheelhorse56 on April 24, 2012, 12:46:32 pm
-
the wrist pin I have is for a model 252707 its from a .030 kit im using the previous piston with a new set of rings .the problem is when installing the pin it seems a little too snug in the piston and the connecting rod moves but it takes a tiny bit of effort . ive built a few chevy 350's and one or two pontiac 400's but this seems a little out of place. :confused:
-
Hone it with a dowel and a scotch brite pad, happens to me sometimes also. Just go slow
-
okay thanks I was considering honing it
-
any opinion on this george? :confused:
-
What Tommy said. Dont doubt him his word is as good as mine.
-
no doubt here just want to make extra sure ive put way too much time into this to mess it up nowht. plus after its done I might auction it off for charity or sell it so it must be purfect. thanks for the info again guys ! id be lost without it