Topic: NEW ARMA Twin SUPER MODIFED

[George Herrin]

here is a video of a few laps we made today doing some more testing. Hope it works.

http://www.youtube.com/watch?v=HtpoDjydG8g

[DoNoHo]

Super good show George

[nic_hayes]

All I can say is, 

[Mike Gentry]

Gonna be a good show  ........... Look's like ya got er handling pretty good 

[George Herrin]

I promise you it handles. And it only gets better.

[George Herrin]

Here is a bit more video. I am learning this stuff slowly.


http://www.youtube.com/watch?v=xuXrM5mYHJU

[Seth Brunson]

WOW Looks great man!!!!! Sounds awesome......Very nice build.

[Jeremy_Conley]

WOW!!! thats gotta be my next build. thats just awesome

[Tony Loveless]

Sounds good George!  Definately not hurting for power lol.

[George Herrin]

Well the maiden race was good and bad. I have no video but it did not like the hi9gh spped of a real track carb issues and a broke stock rocker arm at 8500 rpms Friday in practice (MISSED THE GEARING JUST A TAD) But worked on it got er going again, better run well drives like a dream. OEM carbs are coming off tillys are going on and that should wake this thing up.

[Lawnmower man]

thanks for the info and why didn't you run Sunday george
 
and George im building a super modifed to an i need some help

[George Herrin]

With 154 mowers as a race promoter I had no time to race. I had to ensure the event ran as smoothly as possible

[Rooster]

With 154 mowers as a race promoter I had no time to race. I had to ensure the event ran as smoothly as possible

And you did a right fine job of that!

[George Herrin]

Thanks Rooster that means alot!!!

[jerb]

yup George things went pretty smoothly sunday considering the amount of racers.... i do have a few questions on the super mod chassis, i will be using a step through chassis, my questions, the last 6 or so inches of the chassis in the rear is unboltable, can we remove this and fabricate averything rearward, where the rear axle mounts and seat mounts?? the wheelbase has to remain stock?? and if we use a horizontal shaft engine, where does it need to be posistioned in relationship to a vertical shaft engine?? thanks, gonna get started on this project pretty quickly, will be asking lots more questions i can imagine....