« previous next »
Pages: [1]   Go Down

Author Topic: Gear Ratio  (Read 3475 times)

0 Members and 1 Guest are viewing this topic.

Budracing

  • Guest
Gear Ratio
« on: July 15, 2006, 10:01:21 am »
From the input shaft to the axle in the highest gear is a 13 to 1 gear ratio.  I was wondering what size puleys to run fron the motor to the transaxle to get close to a 9 to 1 gear ratio
Logged

Offline mowdak1

  • Highly Mowtivated
  • ****
  • Posts: 4349
  • Karma: 73
    • View Profile
    • North Dakota Lawn Mower Racing Association
Gear Ratio
« Reply #1 on: July 15, 2006, 10:22:32 am »
http://acmemowersports.com/imow_pulleys.html

Use the IMOW Pulley set up found above. The one pulley is adjustable allowing you to dial in the 9:1 ratio with a fair degree of accuracy.
Logged

Offline jrlawnmowerdad

  • Turf Warrior
  • **
  • Posts: 122
  • Karma: 2
    • View Profile
Gear Ratio
« Reply #2 on: July 15, 2006, 06:20:01 pm »
Well we used a 5 on the motor and a 4 1/2 adjustable on the transaxle and got it dead on.Mike Cupps can get you the pulleys.And pretty much anything else you might need your mower
Chris Curry
Logged
Chris Curry

Budracing

  • Guest
Gear Ratio
« Reply #3 on: July 16, 2006, 11:45:47 pm »
Ok but how do i get a hold of this guy to get the pulleys?
Logged

Offline mowdak1

  • Highly Mowtivated
  • ****
  • Posts: 4349
  • Karma: 73
    • View Profile
    • North Dakota Lawn Mower Racing Association
Gear Ratio
« Reply #4 on: July 16, 2006, 11:47:43 pm »
Well... Mike Cupps would be the gentleman that runs Acme MowerSports per the link above Budracing.
Logged
Pages: [1]   Go Up
« previous next »
 

anything