Author Topic: hub sliding (Read 2639 times)

mowcephus · « **on:** July 13, 2006, 08:11:25 pm »

I just bought a new one piece billet sprocket hub for my axle and gave it a test run and it slide a little towards the left rear tire on my axle. I have the allen screw tight as I could get it and ever put keyed shaft locks on both sides of the hub on the axle. Are they a trick to keep these hubs where they belong?

George Herrin · « **Reply #1 on:** July 13, 2006, 09:41:37 pm »

I cut my keys just big enoguh for the hub it doesn't extend out either side. Then I take slit collar locks and put one on each side with the key side opposite the keyway in the axle. I have never had one move.

speeddemon0308 · « **Reply #2 on:** July 14, 2006, 10:19:43 am »

hm all i have is the set screw tight and it dont move at all

but if the chain isent alinged it will move over the sproket or fall off till it gets alinged

i have the lock collars on eather side of my wheel hub and they have never moved yet even on the out side tire it hasent moved at all

mudmow · « **Reply #3 on:** August 09, 2006, 07:27:06 pm »

where did you get the hubs and what size axle they on

matt25001149 · « **Reply #4 on:** August 09, 2006, 09:12:19 pm »

1'' axel and theyre off of a old mower like a massey ferguson or an old mtd just look for a mower with 3 bolt rims ull probly find some with 3/4 shaft and some with 1'' shaft good luck

News:

Author Topic: hub sliding (Read 2639 times)