« previous next »
Pages: [1]   Go Down

Author Topic: 700 peerless  (Read 2866 times)

0 Members and 1 Guest are viewing this topic.

Offline bob kinner

  • Newbie
  • *
  • Posts: 83
  • Karma: 0
    • View Profile
700 peerless
« on: May 20, 2006, 09:39:22 pm »
i have a 700 peerless transmission with the steel input shaft and bevel gear there seems to be an eccessive amount of verticle movement in the
input shaft. i'de like to know what others have dome to correct this.
Logged

Offline Squidd

  • Global Moderator
  • Highly Mowtivated
  • *****
  • Posts: 6906
  • Karma: 92
  • Gender: Male
    • View Profile
700 peerless
« Reply #1 on: May 20, 2006, 10:23:31 pm »
Should be a thin shim washer and e-clip that holds the shaft down in the case... located out side of case prior to pulley...

Are they both still there...?
Logged
Randy Stys
"Pull My Finger"
 63 Cub Cadet S/A

Offline bob kinner

  • Newbie
  • *
  • Posts: 83
  • Karma: 0
    • View Profile
e clip
« Reply #2 on: May 22, 2006, 02:01:39 am »
should that be an e clip or just on outside snap ring?
Logged

Offline mowdak1

  • Highly Mowtivated
  • ****
  • Posts: 4349
  • Karma: 73
    • View Profile
    • North Dakota Lawn Mower Racing Association
700 peerless
« Reply #3 on: May 22, 2006, 03:09:06 am »
On my 700-714 its simply a snap ring...

Logged

Offline Squidd

  • Global Moderator
  • Highly Mowtivated
  • *****
  • Posts: 6906
  • Karma: 92
  • Gender: Male
    • View Profile
700 peerless
« Reply #4 on: May 22, 2006, 06:38:13 am »
Yep. E-clip/Snap ring...I use the term and the parts interchangably...
Logged
Randy Stys
"Pull My Finger"
 63 Cub Cadet S/A
Pages: [1]   Go Up
« previous next »