the mower started life as a Rally plus mower with a 16.5hp ohv and a hydrostatic drive.
i dont really have any pics of the mower in original form(computer crash) but here is a few pics of progress. Alot of things were done with out pics but i still have more to do so i may be able to fill in some blanks as i finish.
pic of frame before modification
the frame in front of the fourwheeler is another 4 wheeler that will be cut up as frame reinforcement.
pic of sheetmetal after sandblast, in building waiting on dry weather to prime.
front axle in prep. it is 3/16 wall- 1x2 tubing with 1/4 plate steel
finished axle with spindle roughly in place.
i have more pics and it jumps ahead abit because i had to get it mocked up for a car show.but i will post those pics later.
i dont think i thumbnailed them right. i will try again with next pics.
here is the front half of the mower on the frame.
this is with the body sitting in place and a borrowed rear wheel just see how it would look.
it just had the front axle clamped in place and the front trim on it. found out i needed a little more room on the front sidepanels, 38" of width don't quite clear.