V-Twin Modifications
Posted by marsupial72 on Oct 25, 2005, 2:14pm
--------------------------------------------------------------------------------
hey george I have a question for you Im getting ready to start tearing down my motor so I can build it . but Im a little worried about what kind of rings to use we recently built a single cylinder motor with some pretty good compression the rings didnt hold up any suggestion.
Logged
Re: v-twin modifications
Posted by George Herrin on Oct 25, 2005, 7:10pm
--------------------------------------------------------------------------------
What engine are you looking to build.
George
--------------------------------------------------------------------------------
Re: v-twin modifications
Posted by marsupial72 on Oct 26, 2005, 6:58am
--------------------------------------------------------------------------------
20 horse intek v-twin
Re: v-twin modifications
Posted by George Herrin on Oct 26, 2005, 8:13pm
--------------------------------------------------------------------------------
The rings in the intek can handle as much as you can put in it and the starter start it. They are pretty good engines. Have lots a potential. There is no substitute for cubic inches.
George
--------------------------------------------------------------------------------