Topic: Adapting front spindles

[kmowtion]

Is there a way to adapt 3/4" front J-Spindles to fit 5/8" aluminum wheels. I thought about cutting the horizontal part off and welding 5/8" on, but I didn't know if it would hold or not. Anyone here got any ideas?


Thanks,
Pork chop

[George Herrin]

E.C.Distributing sells billet hubs with high speed 3/4 bearings which uses any kart wheel.

[kmowtion]

for a 4 on 4 bolt pattern?

[George Herrin]

Aluminum kart wheels are 3 bolt pattern

[kmowtion]

The wheels I have are 4 on 4...hmmmmm I may have to refigure this thing somehow.
Thanks George

[George Herrin]

only 4on4 i know of are 8 inch you run that big on the front.

[kmowtion]

I'll have to pull them out of the box again and look. I just got them for my winter project build.I know the rear ones are 8" 4x4, and the front ones are 6". If they do have the 3 hole kart pattern, I'll be giving you a call tomorrow George.

Thanks lots,
Pork Chop

[C/P_Racer]

The wheels I have are 4 on 4...hmmmmm I may have to refigure this thing somehow.
Thanks George

They could be four hole 2 13/16 pattern.

[kmowtion]

Hey George, thanks for hooking me up with some front hubs. Can't wait till I get it all together.

Pork Chop

[George Herrin]

Very Welcome I aim to help as many and as much as I can!!!