Couple new things from the shop...
I went to "reinforce" the steering knuckles as George had suggested...
1/8" X 1" flat stock cut to fit and welded in...when I took them apart I did notice one of the tie rod "tabs" had already been bent !!!
I also wasn't too thrilled with the slop in the poly bushings it came with...So I went and picked up some brass bushings...
I had to drill the sleeve out to accept the thicker bushings (finely found a "use" for that 23/32" drill bit I had laying around....
)
Then line bore the inside to a straight snug and smooth fit on the King pin...
While I was at it I drilled, tapped and added grease zerks to help keep things smooth...
What I though was a "deal" at $28 a pair ends up almost as much as some of the better steering sets I've seen and I still have the "generic|" axels...
Next time I'm buyng the good stuff and be done with it...
But for now, I'm pretty happy with the upgrades...