Engine Help > Briggs Flathead
Put a Sleeve in a Kool-bore Briggs engine?
laurw1:
Hey so I have a 25 Cubic inch horizontal briggs engine, it is a kool-bore, meaning the cylinder walls are aluminum, no cast ieon cylinder sleeve. Briggs never made a 25CI or 28CI horizontal briggs with a cast iron cylinder sleeve, but they made vertical engines that had them. Now heres the question, can i put a sleeve in this engine? Ive heard about people putting sleeves in their kool-bore engines, but I would like some advice about what machining I will have to do, where I would get the sleeve, etc.
PJG56:
As long as theirs enough material in the block you should be able to sleeve it
Snapper#67:
Not trying to go-jack this post but Does anyone have a specific sleeve or part # for a sleeve I’m working on resleeving my 28 to a 31,
Snapper#67:
--- Quote from: Snapper#67 on December 29, 2018, 05:07:49 pm ---Not trying to go-jack this post but Does anyone have a specific sleeve or part # for a sleeve I’m working on resleeving my 28 to a 31,
--- End quote ---
Nvm searched around long enough and found my answer!
PJG56:
Melling csl 1147 is what I use
Navigation
[0] Message Index
[#] Next page
Go to full version