Author Topic: Vanguard 38ci head O-ring  (Read 2457 times)

0 Members and 1 Guest are viewing this topic.

Offline mod 76

  • Newbie
  • *
  • Posts: 29
  • Karma: 0
    • View Profile
Vanguard 38ci head O-ring
« on: August 03, 2018, 10:26:15 am »
I'm wondering where and how to position the placement of the groove that needs to be cut into the head.. I've read that it is really tight and there is only one good spot ?? Do I use the steel head gasket as a reference?? Any input , measurements and or pictures would be great

Offline rotten ron

  • Turf Warrior
  • **
  • Posts: 610
  • Karma: 10
  • Gender: Male
    • View Profile
Re: Vanguard 38ci head O-ring
« Reply #1 on: August 03, 2018, 10:28:33 pm »
Make it  close to the head bolt holes,keep it back about .025" that way the heads will fit on any block even with the largest bore possible,I was going to bore a block and not use sleeves and get the bore chromed .

Offline mod 76

  • Newbie
  • *
  • Posts: 29
  • Karma: 0
    • View Profile
Re: Vanguard 38ci head O-ring
« Reply #2 on: August 06, 2018, 12:16:58 am »
Thanks rotten ron

 

anything