Author Topic: High speed needles  (Read 2156 times)

0 Members and 1 Guest are viewing this topic.

Offline Ezpz

  • Newbie
  • *
  • Posts: 5
  • Karma: 0
    • View Profile
High speed needles
« on: May 18, 2018, 12:48:52 am »
Has anyone used the high speed needle valve for a walbro lmt on a single barrel nikki? I'll order one for the walbro but I have a nikki hooked up right now. Just curious how it all lines up, the nikki bowl looks a little deeper. I'm guessing you would take the main jet out of the nikki and have the needle seat right into the white plastic that holds the emulsion tube.

PS if anyone has an inexpensive method to clean the air bleeds and idle circuit on a disgusting ebay walbro im all ears  :D

Offline Mower Maniac

  • Turf Warrior
  • **
  • Posts: 116
  • Karma: 1
  • Gender: Male
    • View Profile
Re: High speed needles
« Reply #1 on: May 19, 2018, 01:14:36 am »
Nikki carbs are not good for the high speed needle, they are junk carbs
AZLMRA
2016-GPK 3rd place
2017-GPK 2nd place

 

anything