Author Topic: vertical to horizontal shaft v-twin  (Read 433 times)

0 Members and 1 Guest are viewing this topic.

Offline DWest

  • Newbie
  • *
  • Posts: 2
  • Karma: 0
  • Gender: Male
    • View Profile
    • West Small Engine Repair L.L.C.
vertical to horizontal shaft v-twin
« on: February 12, 2018, 06:44:14 PM »
Hi folks, I have a Briggs vertical shaft engine 446777 0115 E1  and I need a horizontal shaft.  My question is will the internals from the vertical shaft engine fit into a horizontal shaft block?  I know it is a typical newbie question but that's what I am, a newbie.  Thanks, ....Dan


Dan West                 Southwest Missouri

Offline Eatondirt

  • Turf Warrior
  • **
  • Posts: 160
  • Karma: 1
  • Gender: Male
    • View Profile
Re: vertical to horizontal shaft v-twin
« Reply #1 on: February 12, 2018, 07:03:51 PM »
There was never a horizontal shaft intek.  I know there have been some try it. A vanguard has an horizontal shaft and some of there parts are interchangeable
Casey Eaton
Big Dog Mower Racing

Offline DWest

  • Newbie
  • *
  • Posts: 2
  • Karma: 0
  • Gender: Male
    • View Profile
    • West Small Engine Repair L.L.C.
Re: vertical to horizontal shaft v-twin
« Reply #2 on: February 12, 2018, 07:54:26 PM »
That's what I wanted to know, Thanks!
Dan West                 Southwest Missouri


 

anything