Author Topic: Mower frame question.  (Read 238 times)

0 Members and 1 Guest are viewing this topic.

Offline BPLP

  • Newbie
  • *
  • Posts: 9
  • Karma: 0
    • View Profile
Mower frame question.
« on: November 16, 2017, 07:46:38 AM »
Would it be possible, or more so a good idea, to make the frame that the body of my mower will fit over and then drill holes and bolt the two together? I was going to weld them but together but then it might be hard to keep it from distorting from the heat and so on. Also I think it might be better for maintenance. (this is not going to be a racer so those restrictions don't really apply to me.)



Offline Mower Maniac

  • Newbie
  • *
  • Posts: 72
  • Karma: 1
  • Gender: Male
    • View Profile
Re: Mower frame question.
« Reply #1 on: November 16, 2017, 08:37:38 AM »
Sure, most guy want to do that but we have to use mower frames.
AZLMRA
2016-GPK 3rd place
2017-GPK 2nd place

Offline BPLP

  • Newbie
  • *
  • Posts: 9
  • Karma: 0
    • View Profile
Re: Mower frame question.
« Reply #2 on: November 16, 2017, 09:22:18 AM »
Yeah that's what I thought. I think it would be best just so I can pull the whole body off the frame like an old car or truck. Should I put the bolts through the side of the frame or the top though? would it make a difference?


Offline Mower Maniac

  • Newbie
  • *
  • Posts: 72
  • Karma: 1
  • Gender: Male
    • View Profile
Re: Mower frame question.
« Reply #3 on: November 16, 2017, 06:44:59 PM »
Just put pins on the stuff you raise up, and bolts for fenders
AZLMRA
2016-GPK 3rd place
2017-GPK 2nd place