Author Topic: Peerless 700-770  (Read 373 times)

0 Members and 1 Guest are viewing this topic.

Offline truckintyler

  • Newbie
  • *
  • Posts: 3
  • Karma: 0
    • View Profile
Peerless 700-770
« on: March 23, 2017, 07:10:55 PM »
Building my first race mower , question is my peerless 700 does not look like the one in the peerless 700 race prep " thread .
 The bushings are all open on the sides which seems to me it won't seal up well .
 
Also it did not have an o-ring under the gear on the input shaft but had an o-ring under the pulley side acting as a grease seal.

  Do I need to find a different model 700 or will this one do?
Tags says model 770a serial 61360017
 



Offline chavez

  • Turf Warrior
  • **
  • Posts: 184
  • Karma: 0
  • Gender: Male
    • View Profile
Re: Peerless 700-770
« Reply #1 on: March 23, 2017, 11:03:01 PM »
It'll do just fine. It will be a bit messier due to the open bushings. 700 cases were both ways, no worries.   Should be a lip seal at the lower end of the input once you are done, no seals etc above that. You want the oil getting to those bearings.   
Travis Callaway