Author Topic: Crankshaft Throw  (Read 4145 times)

0 Members and 1 Guest are viewing this topic.

Offline Nod

  • Newbie
  • *
  • Posts: 23
  • Karma: 0
  • Gender: Male
    • View Profile
Crankshaft Throw
« on: October 10, 2016, 05:19:33 am »

Hi,
I'd have though this Question would have been asked along time ago but I could find it in the past post's  :bash:

Is there a different Throw between the 18hp, 20hp, 22hp, 25hp, 27hp and the 30hp Crankshafts, or can I for example fit a 18hp crank in a 30hp Block and not worry that the Piston will not reach the top of the bore.  :confused: :doh:

Nod   

Offline Nod

  • Newbie
  • *
  • Posts: 23
  • Karma: 0
  • Gender: Male
    • View Profile
Re: Crankshaft Throw
« Reply #1 on: November 01, 2016, 05:36:19 am »


 Thanks on Midwest  :D :D :D

Offline Nod

  • Newbie
  • *
  • Posts: 23
  • Karma: 0
  • Gender: Male
    • View Profile
Re: Crankshaft Throw
« Reply #2 on: November 16, 2016, 05:18:03 am »
 

OK,  I've got another Question,

What are the tollerances for the end float an the crankshaft  :confused: taking into consideration that I have a roller bearing in the cover plate with shims. The Engine will be running round about 8000 rpm :D