« previous next »
Pages: [1]   Go Down

Author Topic: murray jackshaft pulley  (Read 3325 times)

0 Members and 1 Guest are viewing this topic.

Offline boomboom

  • Newbie
  • *
  • Posts: 62
  • Karma: 1
  • Gender: Male
    • View Profile
murray jackshaft pulley
« on: April 06, 2016, 08:58:05 pm »
Question fellas......Im using a Murray jackshaft. 5/8 shaft, both ends splined. one end is a fine spline, the other end is isn't. Been hunting ebay, Im looking for matching size pulleys to fit a 1/2" belt. Any leads on who sells the pulleys Im looking for? Thank you!
Logged
Its only cheating if you get caught!

Offline Mower Militia

  • Newbie
  • *
  • Posts: 36
  • Karma: 0
  • Gender: Male
  • "I prefer dangerous freedom over peaceful slavery"
    • View Profile
Re: murray jackshaft pulley
« Reply #1 on: April 06, 2016, 09:57:54 pm »
I would just get a 5/8 keyed shaft and you would have a lot more options on pulleys.
Logged

Offline Jeff McKelroy

  • Professor Ducky
  • Turf Warrior
  • **
  • Posts: 890
  • Karma: 10
  • Gender: Male
    • View Profile
Re: murray jackshaft pulley
« Reply #2 on: May 11, 2016, 01:42:09 pm »
Quote from: Mower Militia on April 06, 2016, 09:57:54 pm
I would just get a 5/8 keyed shaft and you would have a lot more options on pulleys.

Yep, available on McMaster-Carr website http://www.mcmaster.com

a 12" length should do the trick. BE AWARE OF KEYWAY WIDTH, as they are (or used to be) available in 3/16" and 1/4" widths.
Logged
Pages: [1]   Go Up
« previous next »