« previous next »
Pages: [1]   Go Down

Author Topic: Intek head question  (Read 2538 times)

0 Members and 1 Guest are viewing this topic.

Offline Johnson Mowersports

  • Turf Warrior
  • **
  • Posts: 923
  • Karma: 1
  • Gender: Male
  • 23,63
    • View Profile
Intek head question
« on: March 23, 2016, 11:00:38 pm »
I'm looking for the bolt spacing on an Intek v twin intake port any help would be appreciated. Thanks Josh
Logged
Josh

2011 mck stock class champion
2011 super sportsman rookie        2012 MCK Super Sportsman runner up
 2015 ALL AMERICAN BP CHAMPION

Offline Jeff McKelroy

  • Professor Ducky
  • Turf Warrior
  • **
  • Posts: 890
  • Karma: 10
  • Gender: Male
    • View Profile
Re: Intek head question
« Reply #1 on: March 28, 2016, 02:56:06 pm »
I'm coming up with 2.45", measuring complete distance outside of hole to outside of hole, minus .250". BUT being threaded holes, that's only a good guess.
Logged

Offline Johnson Mowersports

  • Turf Warrior
  • **
  • Posts: 923
  • Karma: 1
  • Gender: Male
  • 23,63
    • View Profile
Re: Intek head question
« Reply #2 on: March 31, 2016, 11:20:34 pm »
Thanks I got 63.5cm from center to center so I think I'm close. Trying to find some angled rubber carb intake mounts for the kenhi carbs
Logged
Josh

2011 mck stock class champion
2011 super sportsman rookie        2012 MCK Super Sportsman runner up
 2015 ALL AMERICAN BP CHAMPION
Pages: [1]   Go Up
« previous next »