Author Topic: intek twin mukuni flat slides  (Read 2855 times)

0 Members and 1 Guest are viewing this topic.

Offline zach87cp

  • Turf Warrior
  • **
  • Posts: 400
  • Karma: 2
  • Gender: Male
    • View Profile
intek twin mukuni flat slides
« on: July 27, 2014, 07:19:41 pm »
Hey I was wondering if anyone's running 28 mm flat slides on a intek I have a couple questions I can't get mine tuned in and its driving me crazy lol
Zach Rupert
Rupert Racing
Super Sportsman #87
Sponsored by ace racing engines .

Offline Gui961

  • Turf Warrior
  • **
  • Posts: 206
  • Karma: 0
  • Gender: Male
    • View Profile
    • CTGQ
Re:
« Reply #1 on: July 29, 2014, 12:59:50 pm »
never ran the flat side mikuni but i did a little work with the round slide . did you buy the carb new and are they build for 2 stroke or 4 stroke ... because the 2 stroke one are very very hard to get them to idle right
Guillaume Mercier-Roy

Tech director CTGQ

Pro-Mod #16 powered by vanguard


CTGQ, 10+ years of mower racing in Quebec

Offline zach87cp

  • Turf Warrior
  • **
  • Posts: 400
  • Karma: 2
  • Gender: Male
    • View Profile
Re: intek twin mukuni flat slides
« Reply #2 on: July 30, 2014, 04:29:46 am »
Yea I bought them new off ebay I'm not sure if they were set up for two stroke or four stroke though
Zach Rupert
Rupert Racing
Super Sportsman #87
Sponsored by ace racing engines .

Offline zach87cp

  • Turf Warrior
  • **
  • Posts: 400
  • Karma: 2
  • Gender: Male
    • View Profile
Re: intek twin mukuni flat slides
« Reply #3 on: July 30, 2014, 07:51:31 pm »
The only way I can get it to run good is when its way to lean when I get a nice color on plug it breaks up.I tried moving the needles up and down but doesn't seem to do much
Zach Rupert
Rupert Racing
Super Sportsman #87
Sponsored by ace racing engines .

Offline Gui961

  • Turf Warrior
  • **
  • Posts: 206
  • Karma: 0
  • Gender: Male
    • View Profile
    • CTGQ
Re:
« Reply #4 on: July 30, 2014, 09:08:47 pm »
you have a slow jet for idle the needle is for mid trottle and the main jet is for hi speed. if you break up on top your probably too fat. since you dont spend much time there the the spark plug color is mostly from the needle
Guillaume Mercier-Roy

Tech director CTGQ

Pro-Mod #16 powered by vanguard


CTGQ, 10+ years of mower racing in Quebec

Offline zach87cp

  • Turf Warrior
  • **
  • Posts: 400
  • Karma: 2
  • Gender: Male
    • View Profile
Re: intek twin mukuni flat slides
« Reply #5 on: August 01, 2014, 10:23:11 am »
Thanks ill try moving the needle up a couple clips
Zach Rupert
Rupert Racing
Super Sportsman #87
Sponsored by ace racing engines .