« previous next »
Pages: [1]   Go Down

Author Topic: 31 avs  (Read 1826 times)

0 Members and 1 Guest are viewing this topic.

Offline EUBANK RACING

  • Turf Warrior
  • **
  • Posts: 121
  • Karma: 1
  • Gender: Male
    • View Profile
31 avs
« on: October 08, 2013, 08:30:12 am »
 Got a 31 avs with less than an hour on it bent push rod. going to put piston in my non avs build but was wondering if the heads on these are desireable to run on non avs?
Logged
\"Micah\"

Offline royalblu68f100

  • Mow-Forum Junkie
  • ***
  • Posts: 1195
  • Karma: 4
  • Gender: Male
  • Cartwheels are a helluva ride if you can hold on!!
    • View Profile
Re: 31 avs
« Reply #1 on: October 08, 2013, 08:53:48 am »
They are basically the same. Use the valves that have split lock keepers, not the slip on style keepers like the earlier valves use.
Logged
You never win a race by focusing on one aspect of the race!  Motor isn't everything, but you better have a good one!  Chassis too!  But remember, a driver can take a slow machine and make it faster!  I may not have/be the best of any of these but I'm trying!
Chris Cox- CP/Mod X, AP
2016 ALL AMERICAN CP/Mod X Champion
2015 USLMRA AP Champion
2014 USLMRA AP Runner Up
2013 USLMRA AP Champion
2012 SRUSAAO ModX/CP Champion
2012 USLMRA CP Champion
2012 US Open AP Champion
2011 SRUSAAO MOD-X/CP Champion
2011 USLMRA FX Points Runner up
2011 GALMRA CP Points Champion

Offline shadetree57

  • Turf Warrior
  • **
  • Posts: 226
  • Karma: 0
  • Gender: Male
    • View Profile
Re: 31 avs
« Reply #2 on: October 09, 2013, 10:29:39 am »
I'm running an AVS head on my non AVS engine and it works fine other than I had to do a little trimming on the lower engine shroud. Like Royalblu said, Make sure you get the billet keepers and if your valves have the slip on keepers you'll need different valves.
Logged
Pages: [1]   Go Up
« previous next »