Author Topic: Rule Update: FXS & FXT Frame Width  (Read 3800 times)

0 Members and 1 Guest are viewing this topic.

Offline evansop

  • Moderator
  • Turf Warrior
  • *****
  • Posts: 450
  • Karma: 2
  • Gender: Male
    • View Profile
Rule Update: FXS & FXT Frame Width
« on: January 31, 2013, 11:06:49 am »
From the Desk of Manny & Kerry,

From our understanding there have been numerous comments about the width of the chassis on the FXS & FXT class mowers. However after discussing this several upper class racers we all agree that the width does not give an advantage in any way to the driver, it only eliminates the need of adding a third bearing to the jackshaft. So having a frame with of up to 15” in width wouldn’t be a problem. We have removed the word “and width” from this section to cover this and will now read as below. The Rule Book Date has not changes as we feel this is a minor correction.

2. CHASSIS: Frames, parts, must retain original manufacturers (OEM) specifications (no chopping) re: wheel base length unless modifications specified in particular class.  Material (steel) may be added for structural strength.  It is recommended that front axles be bolted or welded rigid eliminating the stock pivoting.  No rear engine lawnmowers must be front engine traditional style lawn tractor with a hood covering the engine and rear fenders.  No handlebars, to prevent a racer from being pierced in the event of a roll over. All tractors must have been a factory built lawn cutting tractors.

http://www.letsmow.com/wp-content/uploads/2009/03/2013-USLMRA-Rule-Book-PDF.pdf  
Kerry Evans
USLMRA President
Evans Outdoor Power & Promotions
USLMRA Timing and Scoring
USLMRA Steering Committe Member
Dixie Outlaws Safety Director
Owner/Builder 2001 S/P National Champion
e-mail: evansop@bellsouth.net

LetsMow.com
facebook.com/USLMRA