« previous next »
Pages: [1]   Go Down

Author Topic: stock compression height  (Read 2389 times)

0 Members and 1 Guest are viewing this topic.

Offline ajm57

  • Newbie
  • *
  • Posts: 27
  • Karma: 0
  • Gender: Male
    • View Profile
stock compression height
« on: January 21, 2013, 01:54:27 pm »
anyone know off hand what the stock compression height is for a 38 vanny? I'm trying not to have to tear mine down to measure it. Also wondering about the rod lenght.
thanks
Logged
Arthur

Offline toolowtomow

  • Newbie
  • *
  • Posts: 7
  • Karma: 0
  • Gender: Male
    • View Profile
Re: stock compression height
« Reply #1 on: February 02, 2013, 04:03:56 pm »
Not sure what you're reffering to in compression height?  I'm building a 38 right now and took a lot of measurements in my build.  Maybe I can help.
Logged
bpracer

Offline Jeff McKelroy

  • Professor Ducky
  • Turf Warrior
  • **
  • Posts: 890
  • Karma: 10
  • Gender: Male
    • View Profile
Re: stock compression height
« Reply #2 on: February 02, 2013, 04:07:34 pm »
Centerline of wrist pin bore to top of piston.
Logged

Offline toolowtomow

  • Newbie
  • *
  • Posts: 7
  • Karma: 0
  • Gender: Male
    • View Profile
Re: stock compression height
« Reply #3 on: February 20, 2013, 12:22:53 am »
Sorry it took a while to get back to this.  Just did some measuring and if my math is right it came up to .998" from the top of the piston to the center of the wrist pin.  Allowing for any instrument variations, I'd say its pretty close to an inch.  Hope this helps out.
Bobby
Logged
bpracer
Pages: [1]   Go Up
« previous next »