Hopefully by tomorrow I'll have a stocker with an ARC aluminum flywheel. Finished (re)machining the hub tonight. I had a buddy attempt it but he didn't get the right taper. I finally got a 4 jaw independent chuck for my lathe and figured out the taper and used the combination feed to cut it. the taper matched but the hub sat too low on the crank. So I straight bored it another .125", made a sleeve, pressed it in (drilled a .375" hole and plug welded it in) and re-cut the taper. now to get the starter properly adjusted, rig a coil, set the timing and fire it up. Then onto getting a new piston and rod ready, shave and port the head and wait for the Isky cam to get here.
Lester