Author Topic: ball on carb question  (Read 1354 times)

0 Members and 1 Guest are viewing this topic.

Offline lt4000 crafts man

  • Newbie
  • *
  • Posts: 20
  • Karma: 0
  • Gender: Male
    • View Profile
ball on carb question
« on: January 09, 2011, 03:34:13 PM »
I have a kohler cv14s engine. on the carb a little ball fell out from a hole on the inside and smoke is coming out of the hole when I turn it over. I was wondering wether I could just JB weld it or if I have to replace the ball.
Sorry but I just found out there was actually a circular cover on the left side of the carb that fell off. and how do we fix it?



Offline birdman_express

  • I'm not fast...but man I can eat! INTEKS RULE THE PITS!!
  • Global Moderator
  • Highly Mowtivated
  • *****
  • Posts: 3920
  • Karma: 31
  • Gender: Male
    • View Profile
Re: ball on carb question
« Reply #1 on: January 09, 2011, 05:59:07 PM »
Pookie you a new welsh plug back on it.
Marc Baker

ARC Dealer

Marc from ARC.... "Billet Billet"

Powered by a Full Bug E.C. 20HP Vanguard!!!!

Offline Toadworks

  • HEYMOW Welcome Wagon
  • Turf Warrior
  • **
  • Posts: 761
  • Karma: 12
  • Gender: Male
    • View Profile
Re: ball on carb question
« Reply #2 on: January 10, 2011, 09:07:50 AM »
There may have been a small spring in the hole with the ball bearing too. The round disk part is called a welsh plug, you can get them from a rebuild kit for your carb. Figure out which model carb you have and go to Outdoor Distributors dot com and find a parts blow-up for it. That way you'll know if you need a spring and a ball or just a ball. By the way the 'smoke' you see is gas/air vapor.