Now notice with my finger slightly pushing on belt it sits deeper. So as you can see it is simply there to keep belt form whipping back and forth. The guide on this pulley is not as the others. I drilled a hole and tapped it for standard thread and run a flanged nut on a 1/4 inch bolt screw it into the frame and the flange nut is the jam nut to keep it from backing out.
Here is the complete belt system done and everything in plce.
Here you see how I have added the clutch spring. This spring is the deck belt tension spring. I have a spacer under the cod on the clutch the spring hook on it rod keeps it from slipping off. I then drilled and taped a two 3/8 holes between the rear chain tensioner and side frame rail this allows me two seperate places to adjust clutch srping tension.
here is another view of everything from the other end. Now that the drive system is complete I have one more thing to do before going top side and thats assemble the EC front axle. That will be the next picture.