Mocked up the exhaust tonight. All joints just tacked on for now.
All pipes starting from the cylinder head are 1" ID then stepped up to 1.250" and finish at 1.50"
Still have to weld on a "BUNG" for my EGT sensor.
Here is the front pipe from the left head crossing over to the right side.
Here you can see where both left and right pipes exit the chassis on the right side.
(yes...No tire to exhaust clearance issues)
Here you can see the pipes terminate about 1/4" from the edge of the mower deck.
One more pic of the same.
The pipes are tucked right up under the running board. With the chassis ride height set at 4.250" I have 3.750" of ground clearance from the ground to the bottom of the exhaust.
Here is a side view of what it looks like
Another view with a WANNA BE hood scoop for the fun of it!
So at this point the chassis is done. Just have to go thru it and final weld a few locations.
All that is left with the BODY is to make up some screens or covers to go in place of the original headlights.
Then its bodywork and paint time!!!
Then comes ENGINE MOD TIME!!!