got a little bit done in last 2 nights, been working on steering and grill and hood mounts,
this is the front bearing for the steering shaft, im using 3/4'' shaft for the steering shaft, the tubing is light gauge 3/4'' tubing and 1/8'' flat iron for bearing mount.
this is the rear bearing mount for the steering shaft, same light gauge tubing and 1/8'' flat iron, and i made sure i can still get the engine out, just have to pull the shroud, both bearing mounts will be slotted so i can pull the steering shaft off if need be..
this is the front grill mount i built, the flat piece in front will be a good place to mount the front nerf bars onto as well, its 3/16'' flat iron...the bell crank is gonna get redone, im not happy with it, gonna try something different...
this is with the hood installed, fits pretty decent, gonna make some filler panels so it looks better, also have a nice place for a oil pressure gauge and a voltmeter...
just a couple pics of the stance, i like the looks of it so far...tell me what ya think....