went out to the shop and got the spindles built, i used hubs you can get at most farm stores for the spindle barrels with an 1 1/8'' inside diameter!
i cut a short piece of 1 1/8'' shaft to take up the space between the top and bottom bearings, the holes drilled in to the hub are there so i can weld the shaft inside the hub..
here the inner shaft is welded into the hub and then i drill out the inner shaft for the bolt to pass through..
now with the inner piece welded in the bearings sit flush inside the hub, these are 1 1/8'' by 1/2'' sealed bearings..
then i drill a 5/8'' hole into the side of the hub at a 10 degree angle for the grade 8 bolt to be welded too, the spindle bolt goes as far into hub as it will, then it is welded in, if you are unsure about your own welding ability, it would be best to have somebody do it for you, as this weld is very important...now do the same for another one and that is that..
finished spindles with plenty of up and down adjustment for different tire heights..