*mtd 719-0313*
Post by mtdmaniac on Aug 22, 2005, 7:25pm
is an mtd 719-0313 a good transmission/transaxle for a racer? im not
actually racing, so if its not tell me what is bad about it, since my
expectations as a fun toy are different than those of real racers.
------------------------------------------------------------------------
*Re: mtd 719-0313*
Post by George Herrin on Aug 22, 2005, 10:42pm
No it isn't I mow 6 acres and in five years I have put 4 in my grass
cutter, nothing about them is strong enough to hold up to the stress of
a modified mower.
george
------------------------------------------------------------------------
*Re: mtd 719-0313*
Post by mtdmaniac on Aug 23, 2005, 7:59am
thanks george
you just saved me from putting 200 bucks into my mower.
do you have any reccomendations for a cheap setup? i have an old
peerless gearbox, but i cant weld so i cant use that with a rear go kart
axle? what should i do and where can i get parts CHEAP as in about 100
dollars
------------------------------------------------------------------------
*Re: mtd 719-0313*
Post by mtdmaniac on Aug 23, 2005, 2:07pm
sorry about that last message. my typing was off and it seemed like it
was asking a completely stupid question. what i meant to say was:
if you had not answered, i would have put about 200 bucks into parts for
that transaxle, and it, as you said, wouldnt be worth it. i have an old
peerless gearbox, but i cant weld, so that would be a bit difficult,
because of the stepthrough frame. Does anyone have any suggestions on
how i could set this mower up for a cheap amount of money (under $200)
------------------------------------------------------------------------
